Al's Vanguard Hull Build

Post links to YouTube, Vimeo, and others of SEVTEC hovercraft in action!
Post Reply
AJW
Posts: 213
Joined: August 23rd, 2014, 4:43 am
Location: Scotland

Al's Vanguard Hull Build

Post by AJW » July 14th, 2016, 6:22 am

Here is a short video of the Vanguard I am currently building.

The hull is 14 foot X 7 foot and has no wood in its construction. Floor and the 6 inch wide stringers are 25mm thick 6lb core foam & the rest of the hull is made from 12mm thick 4lb core foam.

There is still a little way to go before its ready for 2 pack primer & paint. Just a few more hard points to fit in the rear deck for the prop guard and the front of the thrust frame. Make & fit the two lower air tank panels. Then it will be a matter of tidying and prepping the hull ready for the paint. The engine for this craft will be a Kohler 22 hp vertical shaft


User avatar
bphillip2
Posts: 418
Joined: February 2nd, 2012, 10:29 pm
Contact:

Re: Al's Vanguard Hull Build

Post by bphillip2 » September 23rd, 2016, 7:36 pm

Looks good.

Post Reply