H1 fan panel

Post Reply
highlandhovercraft
Posts: 152
Joined: February 14th, 2012, 3:51 am

H1 fan panel

Post by highlandhovercraft » March 17th, 2012, 12:25 am

I have a couple of questions regarding H1.

On sheet 2 bottom left hand corner it gives the vertical dimension of 56.2". On sheet 3 centre left it gives the overall height of the fan bay as 72". Take away the hover height of 15", this leaves 57" not 56.2". Is this a printing error of am I missing something?

Same panel (H6).
Does it matter what distance the outside edge is from the edge of the fan bore? Working out the top surface from the top of the fan bore then it is 1.875". I am trying to figure out what the top corner radius will be of H1.

User avatar
bphillip2
Posts: 418
Joined: February 2nd, 2012, 10:29 pm
Contact:

Re: H1 fan panel

Post by bphillip2 » March 18th, 2012, 9:25 am

Oh whats .8 inches in the grand scheme of things. Guess it depends on how much head room you want.

You need most of the width to fit the two rings in.

Bryan

highlandhovercraft
Posts: 152
Joined: February 14th, 2012, 3:51 am

Re: H1 fan panel

Post by highlandhovercraft » March 18th, 2012, 10:51 am

I wasn't nit picking, but I just wanted to make sure I am not missing something written on the plan sheets. So if I go an extra inch or so higher & wider at the top of H1 than what is on the plan, it's not going to make any real difference as long as I keep the centre of the fan ducts where they are marked on the plan.

Post Reply